Appendix Display Messages - Yamaha Motif-Rack XS Owner's Manual

Appendix
Display Messages
Messages
All data is initialized upon power-on.
Continue?
Are you sure?
Bulk data protected.
Completed.
Device number is off.
Device number mismatch.
Executing...
Illegal bulk data.
MIDI buffer full.
MIDI checksum error.
MIDI data error.
Mixing Voice full.
Now executing Factory set...
Now receiving MIDI bulk data...
Now transmitting MIDI bulk data...
Please keep power on.
The received MIDI bulk data's type is
not compatible with the current mode/
voice type.
The setting is available upon next
power-on after storing Utility.
104
MOTIF-RACK XS Owner's Manual
Confirms whether you want to execute a specified operation or not. If you press "YES," turning the power on
next time will reset all User data to the default initial settings (factory settings).
Confirms whether you want to execute a specified operation or not.
Bulk data cannot be received because of the setting in the Utility parameters. For details, see page 100.
The specified load, save, format, or other Job has been completed.
Bulk data cannot be transmitted/received since the device number is off.
Bulk data cannot be received since the device numbers don't match.
Never attempt to turn off the power while data is being written to internal memory. Turning the power off in
this state results in loss of all user data and may cause the system to freeze.
An error occurred while receiving the Bulk data or Bulk Request message.
process the MIDI data because too much data was received at one time.
An error occurred when receiving bulk data.
An error occurred when receiving MIDI data. Try again.
The Mixing Voice cannot be stored because the number of Voices already stored has exceeded the
maximum capacity.
Indicates that the factory-programmed settings are currently being restored.
Indicates that this instrument is receiving MIDI bulk data.
Indicates that this instrument is transmitting MIDI bulk data.
The data is being written to Flash ROM. Never attempt to turn off the power while data is being written to
Flash ROM. Turning the power off while this message is shown results in loss of all user data and may cause
the system to freeze (due to corruption of data in the Flash ROM). This may also result in the MOTIF-RACK
XS being unable to properly start up the next time the power is turned on.
This message appears when the MOTIF-RACK XS receives the bulk data for a mode different from the
current mode. Set the MOTIF-RACK XS to the mode same as the one for the bulk data. (If the Bulk data is for
the Voice mode, for example, set the MOTIF-RACK XS to the Voice mode.)
This message appears also when the Voice type (Normal Voice or Drum Voice) of the bulk data is different
from that of the currently selected Voice. Match the Voice type.
This message appears when the value of the IEEE1394 Driver parameter has been changed and stored,
indicating that the setting will be active when the power is turned on next time.
Description