Selecting The Work Disk - Yamaha D24 Owner's Manual

Selecting the Work Disk

The Drive Select function is used to select the internal MO disk drive or an external disk
drive as the work disk.
Press the [UTILITY] button.
1
The UTILITY indicator lights up.
Use the JOG/DATA dial to select "DRIVE SELECT," and then press the [ENTER]
2
button.
The current Drive Select setting appears on the display.
Use the JOG/DATA dial to select one of the following:
3
INT MO —internal MO disk drive (i.e., SCSI ID 2).
EXT SCSI-0 —external disk drive set to SCSI ID 0.
EXT SCSI-1 —external disk drive set to SCSI ID 1.
EXT SCSI-3 —external disk drive set to SCSI ID 3.
EXT SCSI-4 —external disk drive set to SCSI ID 4.
EXT SCSI-5 —external disk drive set to SCSI ID 5.
The default setting is INT MO.
Press the [ENTER] button to activate your selection, or the [CANCEL] button
4
to cancel the Drive Select function.
The D24 mounts the specified disk drive.
Press the [UTILITY] button again to leave utility.
5
The UTILITY indicator goes out.
When the D24 is turned on, the disk drive with the highest SCSI ID is automatically
selected as the work disk. So an external disk drive set to ID 3, 4, or 5 is automatically
selected as the work disk instead of the internal MO disk drive, whose default ID is 2. If
the external disk drive set to ID 0 or 1, the internal MO disk drive is selected, because
its ID is higher.
When you use an external disk drive, make sure that it's turned on before the D24, oth-
erwise, it won't be recognized.

Selecting the Work Disk

D24—Owner's Manual
161