Copying Parts - Yamaha D24 Owner's Manual

96
Chapter 10—Editing Parts

Copying Parts

The Part Copy function is used to copy part of a track. Existing material on the desti-
nation track is overwritten by the Copy function. The source track is unaffected.
The following points, which can be adjusted in sub-frame steps, can be selected when
specifying edit points: LAST REC IN, LAST REC OUT, A, B, or a locate memory from
1 through 99. Note that you must set these points before entering the Part Copy func-
tion. See the Quick Locate Chapter on page 57 for more information about setting
these points.
Press the [EDIT] button.
1
The EDIT indicator lights up.
Use the JOG/DATA dial to select "PART EDIT," and then press the [ENTER] but-
2
ton.
Use the JOG/DATA dial to select "COPY," and then press the [ENTER] button.
3
"PART COPY—FROM TR nn" appears on the display ("nn" being the number of the
track from which the part is to be copied).
Use the JOG/DATA dial to select the source track.
4
You can select individual tracks, track pairs, or all tracks: 1–8, 1/2–7/8, or ALL. To copy
part of a virtual track, assign it to a main track first, and then copy.
Press the [ENTER] button.
5
"COPY TR nn—ST MARK IN" appears on the display ("nn" being the number of the
selected track and "ST" being the start point of the part to be copied).
Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
6
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
Press the [ENTER] button.
7
"COPY TR nn—ST 00:00:00.00.0" appears on the display ("00:00:00.00.0" being the
position of the selected point).
Use the JOG/DATA dial or keypad to adjust the start position, and then press
8
the [ENTER] button.
"COPY TR nn—ED MARK IN" appears on the display ("ED" being the end point of
the part to be copied).
Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
9
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
Press the [ENTER] button.
10
If the duration of the specified part is less than 15 milliseconds, the minimum size, the
message "TOO SHORT" appears.
"COPY TR nn—ED 00:00:00.00.0" appears on the display ("00:00:00.00.0" being the
position of the selected point).
Use the JOG/DATA dial or keypad to adjust the end position, and then press
11
the [ENTER] button.
"COPY TR nn—TO TR nn" appears on the display ("TO TR nn" being the destination
track).
D24—Owner's Manual