Moving The Repeated Portion (Ab) - Boss BR-600 Owner's Manual

Editing the Performance on a Track (Track Edit)
10
Press [ENTER].
fig.02-410
11
Use [CURSOR] and the TIME/VALUE dial to specify
the time of the beginning of the location "T" (To)
where you want the data moved.
12
When you are ready to execute the move, press
[ENTER].
The display will ask "Are you sure?," so that you can
confirm the operation.
13
Press [ENTER].
Move Event is executed.
14
Press [UTILITY] (or press [EXIT] repeatedly) to
return to the Play screen.
* During updating, "Keep power on!" appears in the upper
line of the display, while the lower line shows what is being
processed.
After specifying the time in the procedure above, a "+"
may appear to show that there is a discrepancy between
the actual current position and the position displayed. If
you specify the locations using measures, specify the
locations at each screen using the TIME/VALUE dial to
eliminate the discrepancy.
You can also enter the time using [LOCATOR], [ZERO],
[STOP] + [REW], [STOP] + [FF], and AUTO PUNCH
[IN/OUT].
80
■ Moving the repeated
portion (AB)
Perform the procedure given below to move the portion
from the repeat start (A) to the repeat end (B).
Ex. 1 : Moving to the same track
fig.02-280
Repeat Repeat
Start (A) End (B)
Ex. 2 : Moving to another track
fig.02-290
Repeat Repeat
Start (A) Start (B)
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [
"TRK," and press [ENTER].
fig.02-300
3
Press CURSOR [
"MOV," and press [ENTER].
fig.02-310
TO Time
TO Time
] [ ] to move the cursor to
] [ ] to move the cursor to