Loading Wav/Aiff Files In Br-600 Tracks (Wav/Aiff Import) - Boss BR-600 Owner's Manual

With Macintosh
Loading WAV/AIFF Files in
BR-600 Tracks
(WAV/AIFF Import)
You can take WAV or AIFF files on your computer, such as
files created with audio software applications, and load
them to the BR-600's tracks.
● Wave data in the following formats can be imported.
You cannot import wave data in other formats.
• WAV or AIFF format
• Mono or Stereo
• 8-bit or 16-bit
• Sampling Rate: 44.1 kHz
● Compressed WAV files or AIFF files cannot be
loaded.
● Extremely short waveform data (less than
approximately 1 sec) cannot be loaded.
● The loop point settings within an AIFF file will be
ignored.
● Add the extension "WAV" to imported WAV files
and the extension "AIF" to imported AIFF files.
● If the unit is in the Arrange mode at the time of the
import, it takes place in accord with the timing of the
Arrange mode. On the other hand, if the unit is in the
Pattern mode at the time of the import, it takes place
in accord with the timing of the Pattern mode.
182
1
Connect your computer and the BR-600 with a USB
cable.
2
Confirm that [PAD] is not lit, and with the recorder
stopped, press [UTILITY].
3
Press CURSOR [
"USB," and press [ENTER].
The USB screen appears in the display.
4
Select "IMPORT" with the TIME/VALUE dial, then
press [ENTER].
fig.05-630
5
Use CURSOR [ ] [
to select the track/V-Track to be loaded, then press
[ENTER].
When loading to the tracks in mono
fig.05-640
When loading to the tracks in stereo
* Select the track combination 1/2, 3/4, 5/6, or 7/8.
fig.05-650
] [ ] to move the cursor to
] and the TIME/VALUE dial