Copying The Repeated Portion (Ab) - Boss BR-600 Owner's Manual

After specifying the time in the procedure above, a "+"
may appear to show that there is a discrepancy between
the actual current position and the position displayed. If
you specify the locations using measures, specify the
locations at each screen using the TIME/VALUE dial to
eliminate the discrepancy.
You can also enter the time using [LOCATOR], [ZERO],
[STOP] + [REW], [STOP] + [FF], and AUTO PUNCH
[IN/OUT].
■ Copying the repeated
portion (AB)
Perform the procedure given below to copy the portion
from the repeat start (A) to the repeat end (B).
Ex. 1 : Copying twice to the same track
fig.02-090
Repeat Repeat TO
Start (A) End (B)
Ex. 2 : Copying twice to another track
fig.02-100
Repeat Repeat TO
Start (A) End (B)
Editing the Performance on a Track (Track Edit)
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [
"TRK," and press [ENTER].
fig.02-110
3
Press CURSOR [
"CPY," and press [ENTER].
fig.02-120
4
Turn the TIME/VALUE dial to select "AB" and press
[ENTER].
fig.02-130
Time
5
Use CURSOR [
to select the track/V-Track to copy from, and track/V-
Track to copy to.
6
Press [ENTER].
fig.02-140
Time
7
Use [CURSOR] and turn the TIME/VALUE dial to
specify the time of the beginning of the location "T"
(To) where you want the copied data to be placed.
] [ ] to move the cursor to
] [ ] to move the cursor to
Copy Destination
Copy Source
] [ ] and the TIME/VALUE dial
77