Repeating Playback (Repeat) - Boss BR-600 Owner's Manual

Repeating Playback (Repeat)

By using the "Repeat function" you can repeatedly play
back a specified part. Repeating playback allows you to
check the mixing balance or perform loop recordings (p. 63)
with the punch in/out functions.
Playback repeats in the portion set with Repeat as shown
below.
fig.01-570
Repeat Start
(A)
1
Press [REPEAT] at the point where you want the
repeat to begin (A).
fig.01-202
The [REPEAT] begins to flash, telling you that the
repeat start point (A) has been registered.
2
Press [REPEAT] at the point where you want the
repeat to end (B).
fig.01-580
The [REPEAT] lights up, indicating that the repeat
portion has been registered.
3
If you want to cancel the repeat, press [REPEAT] once
more.
The repeat is cancelled, and the [REPEAT] goes out.
58
Repeat
Time
Repeat End
(B)
4
If you want to save the registration for this repeating
segment, save the song.
"Saving the Current Settings to the Song (Song
Save)" (p. 89)
• There must be at least one second between repeat
start point (A) and repeat end point (B). It is not
possible to set the end point less than one second
away from the start point.
• If you press [REPEAT] at a position before the
repeat start point (A), that earlier position is then
set as the repeat start point (A).