Initializing The Br-600'S Settings; Initializing All The Br-600'S Settings; Initializing The System Settings - Boss BR-600 Owner's Manual

Initializing the BR-600's Settings

Initializing All the BR-600's
Settings
The following settings are initialized together at one time.
• System Settings
• Effects (User Patches/Song Patches)
• Rhythm (Arrangements/Patterns/Drum Kits)
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [ ] [
"INI," and press [ENTER].
fig.06-210
3
Press PARAMETER CURSOR [
cursor to "ALL," and press [ENTER].
The confirmation message "Are you sure?" appears in
the display.
fig.06-220
4
To continue the initialization, press [ENTER].
To cancel, press [EXIT] (or [UTILITY]).
When [ENTER] is pressed, initialization begins.
After the initialization has been completed, you are
returned to the Play screen.
You can perform the same initialization with "INIT
ALL," by holding down INPUT SELECT [GUITAR],
[MIC], and [LINE] while turning the POWER switch
ON, then pressing [ENTER].
However, the initialization cannot be carried out
unless a memory card is inserted in the BR-600 and the
song protect function is switched off.
] to move the cursor to
] [ ] to move the
Initializing the System
Settings
Follow the procedure below to initialize the system
parameters.
A list of the initial settings for each parameter is given in the
"Parameter List" (p. 210).
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [ ] [
"INI," and press [ENTER].
fig.06-230
3
Press CURSOR [ ] [
"SYS," and press [ENTER].
The confirmation message "Are you sure?" appears in
the display.
fig.06-240
4
To continue the initialization, press [ENTER].
To cancel, press [EXIT] (or [UTILITY]).
When [ENTER] is pressed, initialization begins.
After the initialization has been completed, you are
returned to the Play screen.
] to move the cursor to
] to move the cursor to
197