Change Of Oem's Password; Use Of Parameter Level - Siemens LMV36.520A1 Basic Documentation

28.4 Change of OEM's password

P
P
/reset
P
/reset
P
P

28.5 Use of parameter level

The parameters stored in the LMV36... basic unit can be displayed and changed on the parameter level.
Normally, all parameters have been set by the burner manufacturer – with the exception of those for the fuel
train and for fuel-air ratio control.
A description of parameter level 400, which is used for setting the fuel train and the fuel-air ratio curve, is
given in chapter Fuel-air ratio curves – settings and commissioning.
182/248
Building Technologies Division
Infrastructure & Citiies Sector
V h min s %
V h min s %
V h min s %
V h min s %
V h min s %
Basic documentation LMV36...
28 Parameter level
Parameter 042: flashes.
Press to go to level c: for password changes.
/reset
Letter n: for new.
Proceed as described in chapter Entry of password and
enter the new password (5 characters).
After entry of the last character, the password must be
confirmed by pressing
/reset
Letter r: for repeat.
Proceed as described in chapter Entry of password and
repeat entry of the new password.
After entry of the last character, the password must be
confirmed by pressing
/reset
SEt confirms that the new password has been saved.
Parameter 042: flashes again.
.
.
CC1P7544en
25.09.2013