Siemens LMV36.520A1 Basic Documentation page 243

Error
Diagnostic code
code
33
168 #
169 #
170 #
171 #
200 OFF #
201 OFF
UPr0 or #
OFF UPr1
Bit 0
Valency 1
Bit 1
Valency 2..3
Bit 2
Valency 4..7
Bit 3
Valency 8..15
Bit 4
Valency 16..31
202 #
203 #
204 Phase number
205 #
206
0
207 #
0
1
208 #
209 #
210
0
240 #
245 #
250 #
Building Technologies Division
Infrastructure & Citiies Sector
Meaning for the LMV36... system
Communication breakdown
Manual locking by the PC software
Test of lockout
Internal error management
Internal error management
Internal error management
Internal error management
System error-free
Prevention of startup
No operating mode selected
No fuel train defined
No curves defined
Standardized speed undefined
Backup / restore was not possible
Internal error operating mode selection
Internal error
Program stop
Internal error
Inadmissible combination of units (basic unit – AZL2...)
Version compatibility basic unit – AZL2...
Basic unit version too old
AZL2... version too old
Internal error
Internal error
Selected operation mode is not released for the basic unit
Internal error
Internal error
Internal error
Basic documentation LMV36...
30 Error code list
Remedy
was interrupted for more than 30 seconds
PC software made a reset attempt with an error-free system
Make a reset; if error occurs repeatedly, replace the unit
Make a reset; if error occurs repeatedly, replace the unit
Make a reset; if error occurs repeatedly, replace the unit
Make a reset; if error occurs repeatedly, replace the unit
No error
Start prevention due to unparameterized unit
Go to error history, entry 702, for initial cause of the error with shutdown in connection with the first
curve settings
Redefine the operating mode (parameter 201)
Redefine the operating mode (parameter 201).
Make a reset; if error occurs repeatedly, replace the unit
Program stop is active (no error)
Make a reset; if error occurs repeatedly, replace the unit
Make a reset; if error occurs repeatedly, replace the unit
Make a reset; if error occurs repeatedly, replace the unit
Select a released operation mode for the basic unit
Make a reset; if error occurs repeatedly, replace the unit
Make a reset; if error occurs repeatedly, replace the unit
Make a reset; if error occurs repeatedly, replace the unit
243/248
CC1P7544en
25.09.2013