Table of Contents
Advertisement
SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
OVERPRINT
8-54
This parameter specifies overprint control. Overprint lines are print
lines whose carriage control specifies printing with no line spacing
after the last printed line. It takes effect on the next record following
a DJDE END; parameter. If FONTINDEX has been invoked in a JDE
or DJDE, OVERPRINT takes effect at the next logical page
boundary. OVERPRINT parameters are the same as for the LINE
command.
Syntax
OVERPRINT = option(s)
Options
Table 8-41 lists the parameter option(s) and definition(s).
Table 8-45. OVERPRINT parameter option(s) and definition(s)
Option(s)
over-opt
disp
Definition(s)
Options are as follows:
•
PRINT
Specifies that all overprint lines are printed as
they would be on an impact printer, with the
second line printed over the top of the first line
with no regard to previous data, including
character spacing, which may vary between the
two lines of data.
•
IGNORE
Specifies that all overprint lines are ignored.
•
MERGE
Specifies the same instructions as the PRINT
option, except when used with FONTINDEX or
CME processing. (See the "Points to note"
section which follows.)
•
PRINT2
Specifies that up to two consecutive lines are
printed per line—one line and one overprint.
Other overprints for the line are ignored.
Options are DISP and NODISP. These are
nonfunctional parameter options which are
preserved for compatibility with other Xerox laser
printing systems. The number of overprint lines is
always printed on the accounting page.
XEROX DOCUPRINT 180 LPS PDL REFERENCE
Advertisement
Table of Contents
