Table of Contents
Advertisement
1.6
CODED MESSAGES
While the Networker is operating your system, it is also monitoring and controlling every aspect of the system's
performance.
If anything unusual occurs, the Networker will display a message stating "Air-Conditioner Fault – R01 Code#??"
for assistance call the number across the top of the screen. There are two parts to the message: the R01 number
designates which appliance has the fault, and the "Code#??" relates to the type of fault. The screen will also
display the spanner symbol.
Whenever such a message appears, it is a good idea to write it down before doing anything else.
This code contains information that will enable Brivis to deal quickly and easily with anything that requires their
attention. With many of them you will be asked to contact Brivis Service and pass on the message, the model and
type of appliance.
Message repeating
Push the Function button followed by the Key 1 button quickly after to repeat a message.
Resetting
If something has interrupted the unit's operation, the word Reset could appear beside the Key 4 button while a
coded message is scrolling across the top of the display. When this is the case the Key 4 button can be used to re-
start the unit. If the unit does not resume normal operation or the error message re-appears, contact Brivis Service.
1.7
RESET THE ADD-ON SYSTEM
If cooling operation has been interrupted, Reset may appear beside Key 4 while a message scrolls across the top
of the screen. The issue may be resolved by resetting the appliance. However, contact Customer Care if any of
the following occur after resetting:
•
the cooling system does not resume normal operation
•
the error continues to persist
•
other messages appear after clearing the fault.
RESET Not Displaying
a. If RESET is not displaying (adjacent to Key 4), press Fn then Key 1. The error message scrolls across the
top of the screen and RESET displays.
Reset the Cooling
b. Press Key 4 to restart the cooling system. If the cooling system is still operating but the networker is
showing the error message and service symbol, try resetting again. If other messages appear, contact
Customer Care.
Error Persists – Initial Actions
c. If the error persists, turn the networker off using the on/off button and wait for approximately 2 minutes.
d. Turn the networker on. This may reset the cooling system and restore normal operation.
e. If the error persists, disconnect the power supply from the unit at the power point (located near the heater
unit) and wait for approximately 1 minute.
f. Connect and switch on the power supply. If normal operation still does not resume, contact Customer
Care.
Brivis
10
ICE Fixed Speed OIM
Advertisement
Chapters
Table of Contents
