OfficeServ 7100
TECHNICAL MANUAL
6) Tighten the mount locking screws into the remaining two holes among the four
screw holes on the bottom of the OfficeServ 7100 cabinet. At this point, do not
tighten completely, but keep the screws out about 2 mm.
7) Align the screws on the bottom of the OfficeServ 7100 cabinet to the bracket holes,
then pull down the cabinet to lock the cabinet securely.
Figure 2.11 Installation on a Wall (6)
2 mm
Figure 2.12 Installation on a Wall (7)
2.7
Table of Contents
Home Page
INSTALLATION
PART 2 APRIL 2007