Samsung OfficeServ 7100 Technical Manual page 28

Table of Contents
Home Page
OfficeServ 7100 INSTALLATION
TECHNICAL MANUAL PART 3 APRIL 2007
3.3.3 Installing UNI Cards and Daughter Card Modules
The UNI card is a universal base carrier card that can accommodate up to 3 optional
daughter cards. The UNI card by itself serves no function. The UNI card can be
installed in slot 1 and/or slot2.
The UNI card has three positions to mount optional daughter card modules. The
mountable daughter card modules are 4TRM, 4DLM and 4SLM. Up to three modules
can be mounted regardless of the option module type. Any of these daughter cards
can go into any of these 3 positions. The interface ports for each card are located on
the front panel of the UNI card and are labeled accordingly.
Align the module to be mounted to the top connector (16-pin connector). After that,
match the bottom connector (100-pin connector). Push the daughter card in carefully
until the card is fully seated into the connectors. Lock the supporter between the
grooves and the top of each option card with screws.
Remove screws from UNI card before mounting the daughter cards then re-screw them
in to lock down the daughter cards.
4SLM
4TRM
Figure 3.13 Installing the UNI Card
3.11