Interface Cards - Samsung OfficeServ 7100 Technical Manual

OfficeServ 7100
TECHNICAL MANUAL
Ports & LEDs
MC LED

3.3 INTERFACE CARDS

This section describes how to set jumpers and switches of an interface card, how to
install optional daughter cards to an interface card, and how to install interface cards
into slots.
3.3.1 Installing Interface Cards
Interface cards are installed in slot 1 and slot 2 of the cabinet.
slot/card configuration rules.
The Procedure for installing interface cards is as follows:
1) Check the exterior of the interface card for damage. Do not install if damaged.
2) Align each Interface card to the guardrail of the universal slot and slide it in.
Function Description
This LED indicates the status of the MMC+ card access.
- Off: The MMC+ card is not installed.
- On: The MMC+ card is installed, however, is not being accessed.
- Blink: The MMC+ card is installed and is being accessed.
Figure 3.8 Installing Interface Cards
3.8
Table of Contents
Home Page
INSTALLATION
PART 3 APRIL 2007
Refer to table 3.1 for