Mp10 Processor Card; Table 3.2 Parts On The Rear Panel Of The Cabinet - Samsung OfficeServ 7100 Technical Manual

OfficeServ 7100
TECHNICAL MANUAL
Slot
Slot 1 and Slot 2
(universal slots)
NOTE: The OfficeServ 7100 only supports PRI service and does not support T1
service even though the TEPRI and TEPRIa cards support both.
The descriptions about each part on the rear of the cabinet are listed in the table below.
Part
Power Switch
AC Power connector
AC LED
DC LED
Battery Socket
Ground Lug

3.2 MP10 PROCESSOR CARD

This section describes the procedures for setting switches and installing optional
daughter cards on the MP10 as well as installing the MP cards in the processor slot.
The OfficeServ 7100 MP10 (Main Control Processor) controls the system operation.
The MP10 is required for all configurations and goes only in slot 0 of the cabinet.
The MP10 comes standard with a built-in 4 port Voice Mail/Auto Attendant and 8 VoIP
MGI (Media gateway Interface) channels.
controlled by license keys entered in system programming.
Cards Allowed
- OS 7100 Card allowed: UNI cards
- OS 7200/OS7400 Cards allowed: 8DLI, 16DLI2, 8SLI,
16MWSLI, 8COMBO, 8TRK, TEPRIa, MGI-16

Table 3.2 Parts on the Rear Panel of the Cabinet

Power on/off switch for the OfficeServ 7100 system.
Connector for the power cable connection
The LED indicates the input of AC power.
The LED indicates the normal output of DC power.
Connector for an external battery
Connection for system ground cable.
The MGI features and capacities are
3.2
Home Page
INSTALLATION
PART 3 APRIL 2007
Function
Table of Contents