OfficeServ 7100
TECHNICAL MANUAL
2.5 CONNECTING GROUND WIRES
This section describes how to connect an external grounding wire to the OfficeServ
7100 system.
External Grounding
External grounding is required to prevent human injuries and system damage
caused by lightning, static electricity, or voltage surge. The OfficeServ 7100
must be grounded with a grounding wire that has a thickness more than
4.0mm
As shown in the figure below, connect an earth ground to the ground lug behind the
OfficeServ 7100.
IMPORTANT: Follow the grounding requirements described in section 1.2
(Grounding Conditions) when connecting a ground to the system.
2
Figure 2.13 Grounding
2.8
Table of Contents
Home Page
INSTALLATION
PART 2 APRIL 2007