Pre-Installation Information; Site Requirements - Samsung OfficeServ 7100 Technical Manual

OfficeServ 7100
TECHNICAL MANUAL
PART 1. PRE-INSTALLATION INFORMATION

1.1 SITE REQUIREMENTS

Select a location that satisfies the following conditions for safety, temperature, humidity,
power and grounding.
1.1.1 Safety Conditions
• The OfficeServ 7100 system should not be installed near materials that can cause a
fire, such as explosive gas and inflammables. The OfficeServ 7100 system should
not be near equipment that generate electromagnetic waves, such as monitors or
copying machines.
• The installation location should be convenient for distributing trunk lines and
extension lines, for connecting power and grounding wires, and for maintenance
and repair.
• The OfficeServ 7100 system should not be installed in aisles or passageways that
are populated or used for moving equipment.
• Always maintain cleanliness to prevent dust from damaging the card connectors of
the cabinet.
• Before installing the OfficeServ 7100 system, check items such as the electrical
wiring status, grounding status, voltage and frequency.
• Do not expose equipment to direct sun light, corrosive fumes, and constant
vibrations.
• Do not install in close proximity to a fire sprinkler or other sources of water.
• A dedicated commercial AC power outlet is required. Do not use extension cords.
• Ensure that all wires and cables to and from the OfficeServ 7100 do not cross
fluorescent lights or run in parallel with AC wires.
• This equipment is to be installed only in restricted access areas (dedicated,
equipment closets, etc.) in accordance with articles 110-16, 110-17, 110-18 of the
National Electric Code, ANSI/NFPA 70.
1.1.2 Temperature/Humidity Conditions
The conditions for temperature and humidity are as follows:
• Operation temperature: 32°F~113 °F
• Storage temperature: 14°F~122 °F
• Humidity: 10~90 %
Home Page
1.1
Table of Contents
INSTALLATION
PART 1 APRIL 2007