Milnor 30 Series Maintenance Manual page 10

Table of Contents
2.2.1.2. Incorrect Configuration or Connection of Equipment Figure 2: Incorrect Configurations That
2.2.2. Equipment and Procedures That Can Prevent Damage
2.2.2.1. Use the Chemical Manifold Supplied.
2.2.2.2. Close the line.
2.2.2.3. Do not let a vacuum occur.
2.2.2.4. Flush the chemical tube with water.
2.2.2.5. Put the chemical tube fully below the machine inlet.
2.2.2.6. Prevent leaks.
Chapter 3. Routine Maintenance
3.1. Routine Maintenance-30-series, Console style OPL
Washer-extractor
3.1.1. How To Show the Maintenance On a Calendar
3.1.2. Maintenance Summary
3.1.3. How to Remove Contamination
3.1.4. Lubricant Identification and Procedures
3.1.4.1. Grease Gun Procedures
3.1.4.2. Procedures for Motors
PELLERIN MILNOR CORPORATION
Sections
(Document BIUUUM09)
6
Figures, Tables, and Supplements
Let the Chemical Supply Go In the
Machine by a Siphon
Figure 3: Incorrect Configurations That
Let the Chemical Supply Go In the
Machine by Gravity
Figure 4: Examples of Manifolds for
Chemical Tubes. Your equipment can
look different.
Figure 5: A Configuration that Prevents
Flow in the Machine When the Pump
is Off (if the chemical tube and tank
have no pressure)
Table 1: Where to Put Marks On a
Calendar
Table 2: Guards and Related Components
Table 3: Filters, Screens, and Sensitive
Components
Table 4: Fluid Containers
Table 5: Components that Become Worn
Table 6: Bearings and Bushings. See Table
7 for Motors.
Table 7: Motor Grease Schedule. Use the
data in Section 3.1.4.2 to complete this
table.
Table 8: Mechanisms and Settings
Table 9: Contamination Types, Cleaning
Agents, and Procedures
Table 10: Lubricant Identification
Figure 6: Motor Grease Maintenance
Conditions
Table 11: Motor Grease Intervals and
Quantities. Use grease EM (Table 10)