Table of Contents
Advertisement
Adjustment of the take-up reel unit
As the state of roll media during operation always changes depending on the state of roll media finishing (winding
shift) and the environment during printing (such as temperature and humidity), wind the roll media while adjusting.
Adjustment during operation
If the adjustment is left in the initial adjustment state, depending on this state of media, winding problems such as
winding shifts may occur.
In this case, solve the problem by turning the adjustment screw on the plate (left).
Note
‹ Adjustment may be needed several times during a long print, depending on the condition of the media.
When moving the roll media position on the printer, the plate (right) needs to be positioned to meet the media.
62
Loading the media
By turning the adjustment screw on the plate
(left), adjust the position of the tension roller.
Counterclockwise
: The left side of the tension
roller is lowered.
Clockwise
: The left side of the
tension roller is raised.
< Adjustment example >
During take-up, the media shifts in the left
direction. (when viewed from the printer front)
Media
Turn the adjustment screw
counterclockwise.
(The right side of the
tension roller is lowered.)
The media is wound in the right direction.
Media
<Right side>
<Right side>
Advertisement
Table of Contents
