Oki IP-5630 User Manual page 44

11
12
CHECK EDGE GUARD
OK ?
13
SELECT MEDIA TYPE
2 01: PAPER
SELECT MEDIA TYPE
2
14
SELECT MEDIA TYPE
2 01: PAPER
SELECT MEDIA TYPE
2
SELECT MEDIA TYPE
CREATE NEW PRESET
44
Loading the media
XX: XXX
XX: XXX
(Display the media presets)
(Enter the media preset menu)
Lower the pressure roller up / down lever.
After this, follow the instructions on LCD screen.
Note
‹ To lower (press) the pressure roller, lower the pressure
roller up/down lever to the lowest position (see the Note
of Step 6 on page page 42).
Open the front cover and align the media
edge guards over the both ends of the media.
Then, close the front cover.
Check that the media edge guards do not go under the
media and that thick media is not stuck between them.
After visually confirming that the media edge guards are
properly set, press the OK button.
Select the media type.
Select a registered media type using the Up and Down
buttons, then press the OK button.
To create a new media preset
At the end of the media preset list, CREATE NEW
PRESET is displayed.
Press the OK button to enter the media registration
menu.
The procedure to create a preset is the same as in
the MEDIA REG menu.
Press the CANCEL button to cancel the entered
parameters.