Change The Automatic Cleaning Timing - Oki IP-5630 User Manual

Change the automatic cleaning timing

To ensure the print heads' good condition, the printer performs the automatic cleaning. The cleaning mode can be
specified for each media preset. Select the cleaning mode depending on the media characteristics.
BEFORE&AFTER
PRINT
BEFORE&DURING
PRNT
OFF
CAUTION
Pay attention to the following when automatic cleaning is set to OFF.
‹ Missing dots may appear if the cleaning operation has not been performed for a long time.
‹ Manually perform cleaning when the PH RECOVERY RECOMMENDED message is displayed on the panel to prevent the
missing dots problem.
The following procedure explains how to set BEFORE&DURING PRNT for automatic cleaning in the media preset
No.2.
1
PRINTER READY
01: PAPER / 1626mm
2
MENU
2
INFORMATION
3
MENU
2
EDIT MEDIA PRESETS
4
>EDIT MEDIA PRESETS
2 SELECT PRESET NO.
5
>EDIT MEDIA PRESETS
2 MISC SETTINGS
174
Advanced operations
Based on the previous printing operations, the printer performs the automatic cleaning when
starting or when completing the print operation.
Based on the previous printing operations, the printer performs the automatic cleaning when
starting the print operation or during printing.
After cleaning, the printer resumes printing if it was interrupted.
Automatic cleaning is not performed. Set this mode in the following case.
- When printing continuously several data files on media with which differences between
printouts will be noticeable if automatic cleaning is performed between two files.
If automatic cleaning is set to OFF, determine suitable timing to execute cleaning manually.
Press the MENU button.
Press the Down button to select EDIT MEDIA
PRESETS.
Press the OK button.
Press the Down button to select MISC
SETTINGS.
Press the OK button.