D Wiper Cleaning Liquid Check And Supply - Oki IP-5630 User Manual

D Wiper cleaning liquid check and supply

Supply wiper cleaning liquid with the procedure below in the following cases.
- When a printer message prompts you to do so.
- When you notice that the liquid level is low during a daily inspection. Generally, wiper cleaning liquid should be
supplied approximately once per month.
1
PRINTER READY
01: PAPER / 1626mm
2
MAINTENANCE
2 START MAINTENANCE
3
MAINTENANCE
2
WIPER MAINTENANCE
4
>WIPER MAINTENANCE
2
REPLACE LIQUID
5
>>REPLACE LIQUID
2
OK?
6
OPEN COVERS, REPLACE
WIPER CLEANG LIQUID
7
104
Maintenance
,
Press the MAINTENANCE button.
Press the Down button to select WIPER
MAINTENANCE.
Press the OK button.
Press the Down button to select REPLACE
LIQUID, and then press the OK button.
Press the OK button to start the operation.
To cancel the operation, press the CANCEL button.
Open the front cover, and then the capping
unit cover.
Raise the old wiper cleaning liquid bottle a
little and pull out the bottle after making sure
that all the liquid has flowed into the printer.
Note
‹ Visually check that the waste ink bottle is not full before
removing it.