Notes For Configuring With Configo; Select Door Call Signalling By Motion Sensor; Set The Response Delay Time Of The Motion Sensor; Configure The External Push Button - TCS IMM2500 Product Information

09/2013
All functions of the basic module can be set also with the configuration software configo™.
The special functions can be programmed with the configuration software configo™:
– control function 10 (call triggering) on button RED, control function 1 / 2 alternating
on button YELLOW, control function 8 on button GREEN,
– internal call 3 on button RED, internal call 2 on button YELLOW, internal call 1 on
button GREEN,
– acoustic room surveillance on button RED, switching lights on button YELLOW, call
diversion with special functions module on button GREEN
(Note: Before programming the call diversion, the AS-address of the front-door sta-
tion is to be fixed and blocked. So a call diversion to TKI and PFS can be realised.)

Select door call signalling by motion sensor

Several bright LEDs are positioned below the lens system of the motion sensor.
 Factory setting Indication and operating elements, page 8)
Select between blinking, flashing and OFF.

Set the response delay time of the motion sensor

 Factory setting 12 h, can be exactly adjusted in 15 min steps,15 min ... 64 h.

Configure the external push button

External push button with a switch time of at least 1 sec can be connected.
 Factory setting: In basic setting external push button open = closing contact.
Can be configured as opener (in basic setting external push button is closed).
 Factory setting: External push button is available, pressing the external push button
triggers the programmed function of the button RED (internal call in case of internal call
3 und room surveillance or control function 10).
With the configuration software configo™ the setup of the control function 3 and 4 can
be changed alternating by checkmark External push button sends function 3 when
opening and function 4 when closing.
TCS TürControlSysteme AG, TCS Hotline Germany: +49 41 94/ 9 88 11 88
FAX: +49 41 94/ 9 88 129  Mail: hotline@tcsag.de
Notes for configuring with configo ™
23
Subject to technical changes.
PI_IMM2500 1A