For remote control of the button RED
Short text
radio receiver board
radio sensor, wristband
radio sensor, necklace
Build in a radio receiver board
The socket for the radio receiver board is located
on the PCB within the upper cover of the module
with special functions.
Slide the contact pins of the radio receiver
board into the designated socket (position see
adjoining illustration).
Ensure that all 6 poles of the plug of the small
PCB are plugged in the socket.
Place the throw-out antenna in a way, that it
cannot get clamped when snapping-on the
upper cover.
This device meets the requirements of the EU Directive
2004/108/EG by complying the standards: EN 61000-6-3, EN 61000-6-1.
Declarations of conformity for download under www.tcsag.de > Downloads > trade
information.
TCS TürControlSysteme AG, TCS Hotline Germany: +49 41 94/ 9 88 11 88
FAX: +49 41 94/ 9 88 129 Mail: hotline@tcsag.de
26
Accessory
Conformity
Article number
0022930
0022931
0022932
Subject to technical changes.
PI_IMM2500
1A
09/2013