Siemens SIMATIC ET 200SP Operating Instructions Manual page 134

Interrupts/diagnostic messages
9.4 Operating errors
Data and command errors
6054 Scale command error
6055 Weighing command
error
6056 Error trace/ protocol/
logging command
134
Error code Add info
[errorCode] [errorAd‐
dInfo]
9511
9520
9521
9522
9523
9524
9527
9519
6054
9500
9501
9502
9507
9515
9530
9531
6055
9500
9501
9502
9508
9509
9513
9515
9539
9540
9542
9543
9544
9545
9546
9547
9548
9549
9555
6056
Description
Write protection enabled
Increment between calibration digits too small
Sequence of calibration points is not correct
Calibration not yet complete
Calibration digits out of valid range
Calibration weight is 0
Command not permitted in simulation mode
No test operation
Command from the Scale commands group (Zero, Tare, etc.) could
not be executed. Additional information contains details.
Fault present
No stability
Waiting for stability
Dosing active
Not permitted in this weighing operating mode
Current weight is out of defined tare weight range
Current weight is out of defined zero setting range
Command from the Weighing commands group (Start single weigh‐
ing, Start continuous mode, etc.) could not be executed. Additional
information contains details.
Fault present
No stability
Waiting for stability
Dosing is not active
Time not permitted within dosing
Service mode is still active
Not possible in this weighing operating mode
Total set point already reached
Current weight is already above fine shut-off point
Set point too small
Set point too large
Tolerance limits implausible
Relation between fine/trailing weight and set point does not fit
Dosing would result in overfilling
Automatic emptying settings (DR25) are not plausible
No check stop defined
Scale is already empty
Jogging time is set to 0 in DR22
Trace, logging or logbook command was rejected. Additional infor‐
mation contains details.
Operating Instructions, 01/2020, A5E47521010-AA
Technology module TM SIWAREX WP351 HF