Siemens SIMATIC ET 200SP Operating Instructions Manual page 115

Com‐ Command
mand
code
861 SecureDisplay position 1 Shows the SecureDisplay on the HMI in position 1 (see DisplayCa‐
862 SecureDisplay position 2 Shows the SecureDisplay on the HMI in position 2 (see DisplayCa‐
863 SecureDisplay position 3 Shows the SecureDisplay on the HMI in position 3 (see DisplayCa‐
864 SecureDisplay position 4 Shows the SecureDisplay on the HMI in position 4 (see DisplayCa‐
865 SecureDisplay position 5 Shows the SecureDisplay on the HMI in position 5 (see DisplayCa‐
869 Close SecureDisplay
870 Smallest SecureDisplay
871 Display serial number of
the electronic weighing
system
875 Display firmware version
of the electronic weigh‐
ing system
876 Display SecureDisplay
Software Version
881 Show first log book entry Shows the first log book entry in SecureDisplay (command only relevant
882 Display last log book en‐
try
883 Previous log book entry
884 Next log book entry
891 Display protocol
Table 6-8 Scale commands
Com‐ Command
mand
code
1001 Zero
1011 Tare
1012 Delete Tare
1013 Activate Preset Tare
1016 Active preset tare from
SIMATIC controller
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA
Description
li.xml).
li.xml).
li.xml).
li.xml).
li.xml).
The command completely closes the SecureDisplay application. Se‐
cureDisplay must restarted in this case with a script call in the HMI/PC.
Shows the SecureDisplay on the HMI with the smallest zoom factor (see
DisplayCali.xml).
Display serial number of the electronic weighing system and in the Se‐
cureDisplay for 5 seconds.
Display firmware version and checksums of the electronic weighing
system in the main display (serial number only) and the SecureDisplay
for 5 seconds.
Display version of SecureDisplay in the main display and the Secure‐
Display for 5 seconds.
for scales requiring official calibration).
Shows the last log book entry in SecureDisplay (command only relevant
for scales requiring official calibration).
Show the previous log book entry in SecureDisplay (command only
relevant for scales requiring official calibration).
Show the next log book entry in SecureDisplay (command only relevant
for scales requiring official calibration).
Displays the last requested protocol from DR46 in a legal-for-trade
manner in SecureDisplay.
Description
Set to zero (semi-automatic)
Taring (semi-automatic)
Delete current tare weight
Preset tare value from DR15 is applied.
The preset tare is taken from the cyclic SIMATIC interface.
Parameter assignment/addressing
6.31 Commands
Write pro‐
tection
Write pro‐
tection
115