Appendix E. Cellular Module Regulatory Information; Important Information For Australian Users; Rf Exposure - Campbell CELL200 Series Product Manual

Appendix E. Cellular module
regulatory information
E.1 Important information for Australian
users
NOTE:
This equipment has been tested and found to comply with the relevant Australian standards.
These standards are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual and/or specifics regulations , may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case the user will be required to correct the interference at his
own expense.
WARNING:
Changes or modifications to this device not expressly approved by Campbell Scientific could
void the user's authority to operate this equipment.
E.2 RF exposure
In accordance with the Australian standard requirements of human exposure to radio frequency
fields, the radiating element shall be installed such that a minimum separation distance of 23 cm
should be maintained from the antenna and the user's body.
WARNING:
This product is only to be installed by qualified personnel.
To comply with FCC/IC regulations limiting both maximum RF output power and human
exposure to RF radiation, the maximum antenna gain must not exceed the specifications listed in
the following tables for the device used.
CELL200-Series 4G LTE Cellular Module 86