Pre-Installation; Establish Cellular Service; Install The Sim Card - Campbell CELL200 Series Product Manual

2. Pre-installation

TIP:
Check www.campbellsci.com.au
software and data logger operating system (OS).
Updating the OS during system setup and testing, or onsite is recommended. Sending an OS
to a remote data logger will interrupt the data logger program. If you have questions, contact
Campbell Scientific for assistance (https://www.campbellsci.com.au/support).

2.1 Establish cellular service

For better security, we recommend using Konect PakBus® Router with a private dynamic IP
address. This method allows only incoming PakBus communication. No other incoming
communication is supported. However, all forms of outbound communication from the data
logger are supported, including but not limited to PakBus, email, and FTP.
Private dynamic IP addresses are standard with Telstra SIMs if no additional services have been
provisioned on the account by a Telstra partner.
A public static IP address can also be used. This provides more incoming communication
functionality, but is less secure and more vulnerable to unsolicited traffic.
NOTE:
A public static IP account must be used when the module is set up in serial server mode.
Private dynamic IP accounts do not support the serial server mode.

2.2 Install the SIM card

The CELL200 series requires a Micro-SIM (3FF) (6 position / contacts); a smartcard that securely
stores the key identifying a mobile subscriber. You should only need to install the SIM once in
the life of the module.
to ensure you are using the latest data logger support
CELL200-Series 4G LTE Cellular Module 2