Configure Cell200 Series; Configure Data Logger; Set Up Hardware - Campbell CELL200 Series Product Manual

6.4.2.1 Configure CELL200 series

1. Connect a USB cable between your module and computer.
2. Connect the cellular antenna. When using a MIMO antenna with multiple cellular
connections, connect the primary cable to Cellular and the secondary to Diversity. If the
cables are not marked in this way, they can be connected to either antennna port. See
Antenna connections
3. Open a web browser and go to: cell.linktodevice.com.
TIP:
If this doesn't work browse to 192.168.86.1.
4. On the Settings tab, enter the APN provided by your cellular provider.
5. If you will be connecting through CS I/O, select the desired SDC Address.
6. If you will be connecting through RS-232, select the desired RS232 Baud Rate.

6.4.2.2 Configure data logger

1. Connect to your data logger using Device Configuration Utility.
2. If using the Konect PakBus Router:
a. On the Datalogger tab, change the data logger PakBus Address and optional
PakBus/TCP Password to match the values entered in the Konect PakBus Router
setup.
b. On the Network Services tab in the PakBus/TCP Client field, enter the DNS address
and Port number noted during the Konect PakBus Router setup.
3. On the PPP tab, set Config/Port Used to the CS I/O SDC address selected in the module or
RS-232 depending on how you will be connected to the data logger.
4. Verify the Modem Dial String setting is blank.
5. (Optional) If using CS I/O communication, the throughput can be enhanced by changing
the SDC Baud Rate from 115200 to 460800. On the Advanced tab, set the SDC Baud Rate to
460800. Note that if there are other devices on the CS I/O port, they all must be able to
support this higher baud rate.

6.4.2.3 Set up hardware

1. Connect the cellular antenna, if it is not already connected. When using a MIMO antenna
with multiple cellular connections, connect the primary cable to Cellular and the secondary
(p. 28).
CELL200-Series 4G LTE Cellular Module 32