Action Commands - Campbell CELL200 Series Product Manual

set roaming ###
set sdc ###
set trusted 1 ###
set trusted 2 ###
set trusted 3 ###
set trusted 4 ###
set ping ###
D.4 Action commands
Action commands are used to perform actions on the modem such as entering low power mode,
rebooting, checking for updates, clearing usage, and more.
check update
clear logs
clear usage
deep sleep
ping ###
reboot
refresh network
reset module
start modupdate
Sets the roaming capabilities of the cellular modem. ### is a
string. Accepted values are Auto and Disabled .
Sets the modem SDC address for the CS I/O port. ### is a number.
Accepted values are 7 , 8 , 10 , and 11 .
Sets the address or DNS Names in the 1st Trusted IP Host field. ###
is a string.
Sets the address or DNS Names in the 2nd Trusted IP Host field.
### is a string.
Sets the address or DNS Names in the 3rd Trusted IP Host field.
### is a string.
Sets the address or DNS Names in the 4th Trusted IP Host field.
### is a string.
Enables or disables ping in the modem. ### is a string. Disabled
and Enabled are the only two values that are accepted.
Starts the process that checks for both a new CELL200 series OS,
and module firmware.
Resets all the logs in the modem.
Resets the usage counts in the modem.
Puts the modem into low power mode. Modem will not respond
across the cellular network.
Used to ping a specific TCP/IP address or DNS name via the
terminal. ### is a string. For example: ping 8.8.8.8 or ping
jarvis.ag1t.net.
Forces the modem to reboot.
Forces the modem to refresh its connection to the cellular network.
Useful for when the network goes stale (long periods of inactivity).
Resets the cellular chipset only.
Starts the over-the-air module firmware update.
CELL200-Series 4G LTE Cellular Module 84