Test The Connection; Serial Client Mode Option - Campbell CELL200 Series Product Manual

6.4.3.5 Test the connection

After the Network Map has been configured, test the cellular connection by using the Connect
screen as shown in the following image. Click on the appropriate station and click Connect to
initiate a call to the data logger.
TIP:
The connection time is subject to many external factors. It is often less than 30 seconds but
could be up to 15 minutes. Be patient.
If the connection is successful, the connectors at the bottom of the screen will come together and
clock information from the data logger will be displayed in the Station Date/Time field. If the
connection fails, a Communications Failure message will be displayed.

6.4.4 Serial client mode option

This mode requires CELL200 series operating system 2.00 or newer. Find the CELL200 series OS
version in the OS Date field of the Status Tab. For more information, see
system and firmware (p. 64).
Updating the operating
CELL200-Series 4G LTE Cellular Module 43