Configure Cell200 Series - Campbell CELL200 Series Product Manual

In serial server/client mode the module connects to the cellular network and opens a listening
port. When a client connects to the listening port, the CELL200 series will be in "serial server"
mode. In serial server mode, all data on the active port (RS-232 or CS I/O) will be routed through
the listening port. When no client is connected to the listening port, the CELL200 series will be in
"serial client" mode and all data on the active port will be sent and received through the initiated
TCP client socket connection.
The incoming connection, or serial server mode, takes precedence. An outbound, or client,
connection will be interrupted if a connection is made on the incoming, or server, listening port.
NOTE:
Instructions in this section assume that you have established cellular service and the SIM card
has been installed as described in

6.4.5.1 Configure CELL200 series

To set up the CELL200 series in serial server/client mode:
1. Connect a USB cable between your module and computer.
2. Connect the cellular antenna. When using a MIMO antenna with multiple cellular
connections, connect the primary cable to Cellular and the secondary to Diversity. If the
cables are not marked in this way, they can be connected to either antennna port. See
Antenna connections
3. Open a web browser and go to: cell.linktodevice.com.
TIP:
If this doesn't work browse to 192.168.86.1.
QuickStart (integrated mode)
(p. 28).
(p. 8).
CELL200-Series 4G LTE Cellular Module 50