Configure Cell200 Series - Campbell CELL200 Series Product Manual

NOTE:
Instructions in this section assume that you have established cellular service and the SIM card
has been installed as described in

6.4.3.1 Configure CELL200 series

To set up the CELL200 series in serial server mode:
1. Connect a USB cable between your module and computer.
2. Connect the cellular antenna. When using a MIMO antenna with multiple cellular
connections, connect the primary cable to Cellular and the secondary to Diversity. If the
cables are not marked in this way, they can be connected to either antennna port. See
Antenna connections
3. Open a web browser and go to: cell.linktodevice.com.
TIP:
If this doesn't work browse to 192.168.86.1.
4. On the Settings > General tab, enter the APN provided by your cellular provider.
5. Set Mode to Serial Server.
6. On the Settings > Serial Mode Setup tab, set Serial Server Listen Port Number. Default is
3001. This is entered along with the IP address as part of the LoggerNet configuration.
7. When using a CR200(X), set RS-232 baud rate to 9600 baud.
QuickStart (integrated mode)
(p. 28).
(p. 8).
CELL200-Series 4G LTE Cellular Module 38