SATO CT4-ex-RF Operator's Manual page 29

Fine-tuning the Label Stop Position and Label Cutting Position
If the label stop position and label cutting position is not adequate, fine-tune it
with the "Stop position potentiometer" inside the front cover. Before fine-tuning
the stop position, set the number 6 of the DIP switches on the right side of the
potentiometer to OFF (lower position). Use the attached tuning driver alongside
the media holder. Move the DIP switch with the straight slot side and turn the
potentiometer with the cross slot side of the tuning driver.
Counterclockwise: The label will stop earlier than the present position (in the
position nearer the printer).
Clockwise: The label will stop later than the present position (in the position apart
from the printer)
If the stop position potentiometer is moved while number 6 of the DIP switches is
ON, the darkness level is altered. Please note it.
Before use, check the following that shows the specifications of usable media in the
printer.
 Thickness (including liner) is from 0.08 to 0.19 mm (0.003 to 0.007 inches).
For details, contact your SATO reseller or technical support center.
 Cutting accuracy is ± 1.5 mm (0.06 inches).
 Workable cutting pitch of the cutter unit is from 20 to 400 mm (0.79 to 3.9 inches).
However, cutting size could be limited depending on some printing conditions.
 After fine-tuning, the cutting position levels off by dispensing 2 to 5 labels.
Stop position
potentiometer
(VR1)
* Tuner on the left
DIP switch
ON
OFF
27