How To Check The Running Mat For Proper Lubrication; Belt Tracking Adjustment - Master F-08 Manual

3. Periodically lubricate the front and rear rollers to keep them at there peak performance.
If the treadmill belt/deck/roller is kept reasonably clean it is possible to expect over 800 hours
before additional re-lubing is necessary.

4.4 How to check the running mat for proper lubrication

1. Disconnect the main power supply.
2. Fold the treadmill up into the storage position.
3. Feel the back surface of the running mat.
If the surface is slick when touched, then no further lubrication is needed.
If the surface is dry to the touch, apply a suitable silicone lubricant.
We recommend you use a silicone based spray to lubricate your Lifespan Treadmill. This
Can be purchased from your local sports Retailer or a local hardware store.
4.5 Belt Adjustment
Belt Tension Adjustment
It is very important for joggers and runners in order to provide a smooth, steady running surface.
Adjustment must be made from the right and left rear roller in order to adjust tension with the
Hexagonal Wrench provided in the parts package. The adjustment bolt is located at the end of
the rails as noted in diagram below:
Left bolt
Note: Adjustment can be done with the small hold on the end caps.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and
left bolt clockwise reasonably and inspect for proper tension. When an adjustment is made to
the belt tension, you must also make a tracking adjustment to compensate for the change in belt
tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing
failure.

4.6 Belt Tracking Adjustment

This treadmill is designed to keep the belt reasonably centred while in use. It is normal for
some belts to drift near one side while the belt is running with no one on it. After a few minutes
Right bolt
EN