Avaya S8730 Maintaining Manual page 37

6. Verify that all port board alarms are resolved.
Maintaining the Avaya S8730 Server for Modular Messaging
a. Access the Dialogic Line Test application by clicking Start > Programs > Avaya
Modular Messaging > Dialogic Line Tester .
b. In the Dialogic QSIG — Line Test Application (or DL Test) window, verify that
all port numbers and channel designations are listed.
The name of the window varies, depending on the type of port board that is
installed.
c. Test the incoming call connectivity of all ports by dialing each port individually
from the same PBX. For QSIG boards, repeatedly dial the number for that group
of ports. The switch connects to the next port in the list for each new call. For
analog and DSE boards, dial individual port extensions.
d. Check the Status column to verify that each port shows Received call followed
by Connected.
The system should answer each connected call with a standard welcome
message.
e. Test the outcalling capability of all ports by first selecting a port in the Dialogic
Line Test Application window under Port Number.
f. Type the number of an extension on the PBX in the Dial Number field and click
Dial Number.
g. When the dialed extension rings, answer the call and hang up.
h. Select the next port number and click Dial Number again.
i. Repeat dialing until all ports are tested.
j. After testing is complete, close the Dialogic Line Test Application window.
For additional information and a list of Dialogic Line Test Status Messages, see the
port board appendix of Avaya Modular Messaging Installation and Upgrades.
Configuring and testing the port board
June 2009 37