Purging Air From The Hydraulic System; Checking The Hydraulic System Fittings - Toro Spray Master Series Operator's Manual

Purging Air from the
Hydraulic System
Note:
You must purge air from the hydraulic system
when you remove any hydraulic components,
including oil filter, or disconnect any hydraulic lines.
1. Open the drive release valves at each hydraulic
pump (Figure 102).
Figure 102
1. Drive release valves
2. Raise the back of the machine until both drive
wheels are off the ground, and support the
machine with jack stands.
3. Start engine and move throttle control ahead to
full throttle position.
4. Move the traction-control levers to the
and positions several times position.
REVERSE
5. Move the traction-control levers to the
position, and shut off the engine.
6. Lower the machine and remove the jack stands.
7. Close the drive release valves at each hydraulic
pump
8. Check the hydraulic fluid level, start the engine,
and run it at full throttle for several minutes, refer
to Checking the Hydraulic Fluid Level (page
9. Shut off the engine, and Install the knee pad
refer to
Checking the Hydraulic
System Fittings
Service Interval: Every 40 hours
Check the hydraulic hoses and fittings for leaks,
damage, or wear. Repair any leaking, damaged, or
worn hydraulic components.
g318733
g313240
FORWARD
72
(Figure 102).
Installing the Knee Pad (page
NEUTRAL
70).
52).