5.
With the tension arm pulled away from the
pulley system, route the new belt, starting at the
hydraulic-motor pulley, then around the engine
pulley and tensioner pulley
1. Engine pulley
2. Belt
6.
Tension the belt; refer to
Tension (page
67).
7.
Lower the machine from the jack stands.
Adjusting the Belt Tension
1.
Ensure that the tension arm and pulley move
freely.
2.
While holding the eye bolt from rotating, tighten
the locknut until the thread length after the
adjustment is 32 mm (1-1/4 inches) as shown
in
Figure
93.
(Figure
92).
Figure 92
3. Tensioner pulley
4. Hydraulic-motor pulley
Adjusting the Belt
g313343
67
Figure 93
g313348