Changing The Engine Oil And Engine-Oil Filter - Toro Spray Master Series Operator's Manual

Figure 70
1. Filler neck
2. Dipstick
5. Remove the dipstick from the filer neck, and
check oil level on the dipstick
Note:
The engine oil level must cover the
hatch-marked area of the dipstick
6. If the oil level is low, wipe off the area around the
filler neck and add the specified oil
until the oil level is between the hatch marked
areas on the dipstick.
Important:
Do not overfill the engine with
oil.
Figure 71
g312873
3. Maximum oil level
(dipstick)
4. Minimum oil level (dipstick)
(Figure 70).
(Figure 70).
(Figure 71)
g312871
Changing the Engine Oil
and Engine-Oil Filter
Service Interval: After the first 5 hours
Every 100 hours (more often under severe
condition).
Draining the Engine Oil
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page
2. Align the oil-drain hose out the left side of the
machine, and remove the plug from the hose
(Figure 72).
Note:
Allow the engine oil to drain completely.
1. Drain hose
2. Plug
3. Install the drain plug into the hose, and tighten
the plug (Figure
Note:
Wipe clean any residual oil.
56
51).
Figure 72
3. Install the drain plug into
the hose.
72).
g312973