Transporting The Machine - Toro Spray Master Series Operator's Manual

Figure 56
1. Flow-regulator case
2. Atomizer slot
(aligned—correct)
7. Rotate the nozzle cap 90° clockwise
8. Repeat steps 1 through
nozzles.
g311417
3. Atomizer slot (incorrect)
(Figure 55).
7 for the other spray

Transporting the Machine

Do not exceed the weight of the machine with both
the sprayer tank and hopper empty or with both the
sprayer tank and hopper full when towing a trailer;
refer to Specifications (page
CAUTION
This machine does not have turn signals,
lights, reflective markings, or a slow
moving vehicle emblem. Driving on a street
or roadway without such equipment is
dangerous and can lead to accidents causing
personal injury.
Do not drive the machine on a public street
or roadway.
Note:
Refer to the chemical warning product
label(s) before transporting the machine and follow
all local/state/federal requirements for transporting
chemicals.
Note:
Make sure that the spreader hopper cover and
the spray wand are secure before transporting.
Loading the Machine
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death.
• Use extreme caution when operating a
machine on a ramp.
• Back the machine up the ramp and walk it
forward down the ramp.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
• Do not attempt to turn the machine while
on the ramp; you may lose control and
drive off the side.
• Use only a single, full-width ramp; do not
use individual ramps for each side of the
machine.
• If you must use individual ramps, use
enough ramps to create an unbroken ramp
surface wider than the machine.
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
the necessary brakes, lighting, and marking as
required by law. Please carefully read all the safety
instructions.
46
17).