How To Remove The Powered Extension Deck (If Equipped) - Genie GS-2646AV Service And Repair Manual

Service and Repair Manual
Platform Components
8 At the steer end of the extension deck, locate,
tag and disconnect the front gate proximity
switch from the limit switch harness.
9 Position a forklift at the steer end of the
machine with the forks even with the bottom of
the platform extension deck.
10 Carefully slide the platform extension out until
the platform extension deck makes contact
with the carriage on the forklift.
11 Secure the platform extension deck railings to
the carriage of the forklift to support the
platform extension deck.
12 Carefully slide the platform extension out and
away from the platform and place it on a
structure capable of supporting it.
Crushing hazard. The platform
extension will become
unbalanced and fall when
removed from the machine if not
properly supported and secured
to the forklift.
72
How to R emove the Power ed Ex tensi on Dec k (if equi pped)
How to Remove the Powered
Extension Deck (if equipped)
1 Remove the platform controls from the
platform and set the platform controls to the
side.
2 Working at the steer end of the platform,
remove the fasteners securing the banjo bolt
to the rod end of the extension deck cylinder.
Set the banjo bolt and fasteners to the side.
3 Manually extend the extension deck
approximately 4 ft / 12 m.
4 At the steer end of the extension deck, locate,
tag and disconnect the front gate proximity
switch from the limit switch harness.
GS-2646 AV • GS-2646 AV35
1 cable track
2 banjo bolt
3 proximity switch harness (located behind
toeboard)
September 2016
Part No. 1272218