Torque Procedure - Genie GS-2646AV Service And Repair Manual

September 2016
SAE O-ring Boss Port
(tube fitting - installed into Aluminum)
(all types)
SAE Dash Size
-4
-6
-8
-10
-12
-16
-20
-24
Adjustable Fitting
1 jam nut
SAE O-ring Boss Port
(tube fitting - installed into Steel)
SAE Dash Size
-4 ORFS / 37° (Adj)
ORFS (Non-adj)
37° (Non-adj)
-6 ORFS (Adj / Non-adj)
37° (Adj / Non-adj)
-8 ORFS (Adj / Non-adj)
37° (Adj / Non-adj)
-10 ORFS (Adj / Non-adj)
37° (Adj / Non-adj)
-12 (All types)
-16 (All types)
-20 (All types)
-24 (All types)
Part No. 1272218
Torque
14 ft-lbs / 19 Nm
23 ft-lbs / 31.2 Nm
36 ft-lbs / 54.2 Nm
62 ft-lbs / 84 Nm
84 ft-lbs / 114 Nm
125 ft-lbs / 169.5 Nm
151 ft-lbs / 204.7 Nm
184 ft-lbs / 249.5 Nm
Non-adjustable fitting
Torque
15 ft-lbs / 20.3 Nm
26 ft-lbs / 35.3 Nm
22 ft-lbs / 30 Nm
35 ft-lbs / 47.5 Nm
29 ft-lbs / 39.3 Nm
60 ft-lbs / 81.3 Nm
52 ft-lbs / 70.5 Nm
100 ft-lbs / 135.6 Nm
85 ft-lbs / 115.3 Nm
135 ft-lbs / 183 Nm
200 ft-lbs / 271.2 Nm
250 ft-lbs / 339 Nm
305 ft-lbs / 413.5 Nm
GS-2646 AV • GS-2646 AV35

Torque Procedure

Seal-Lok™ fittings
1 Replace the O-ring. The O-ring must be
replaced anytime the seal has been broken.
The O-ring cannot be re-used if the fitting or
hose end has been tightened beyond finger
tight.
Note: The O-ring in Parker Seal Lok™ fittings and
hose end are custom-size O-rings. They are not
standard size O-rings. They are available in the
O-ring field service kit (Genie part number 49612).
2 Lubricate the O-ring before installation.
3 Be sure the O-ring face seal is seated and
retained properly.
4 Position the tube and nut squarely on the face
seal end of the fitting, and tighten the nut
finger tight.
5 Tighten the nut or fitting to the appropriate
torque. Refer to the appropriate torque chart in
this section.
6 Operate all machine functions and inspect the
hose, fittings and related components to
confirm there are no leaks.
Service and Repair Manual
Specifications
7