Scissor Assembly - Genie GS-2646AV Service And Repair Manual

September 2016
9-1

Scissor Assembly

How to Disassemble the Scissor
Assembly
Bodily injury hazard. The
procedures in this section
require specific repair skills,
lifting equipment and a suitable
workshop. Attempting this
procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
1 Remove the platform. Refer to Repair
Procedure, How to Remove the Platform.
2 Support and secure the entry ladder to an
appropriate lifting device.
3 Remove the fasteners from the entry ladder
and remove the entry ladder from the
machine.
Crushing hazard. The entry
ladder will fall if not properly
supported and secured to the
lifting device.
Part No. 1272218
4 Remove the cables from the number 4 cable
bridge and lay them off to the side.
5 Disconnect the number 4 cable bridge from
the number 4 outer arm (index #13) and
remove the cable bridge from the machine.
6 Remove the retaining fasteners from the
number 5 pivot pin (index #1).
GS-2646 AV • GS-2646 AV35
Service and Repair Manual
Scissor Components
Cable bridge legend
1 cable bridge 4
2 cable bridge 3A
3 cable bridge 3B
4 cable bridge 2A
5 cable bridge 2B
6 cable bridge 1
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
61