2
Turn the bulb base
counterclockwise and remove it.
3
Remove the light bulb.
4
Install a new light bulb and then
install the bulb base to the light unit
by inserting it and turning it clock-
wise.
After installing the bulb base, wiggle it
lightly to make sure it is securely installed
and turn on the back-up lights to visually
check that there is no light leaking from
between the bulb base and light unit.
Install the cover.
5
� � � � � � � � � � � � � � � � �
6-3. Do-it-yourself maintenance
Align the tabs of the cover with the grooves
and install the cover.
WARNING
To prevent injury
■
Before performing any light bulb
replacement procedure, be sure to turn
the power switch off. Failure to do so may
result in burns from hot components or a
part of your body may get caught on an
operating component, possibly causing
serious injury.
Replacing light bulbs
■
Turn off the lights. Do not attempt to
●
replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may
cause burns.
Do not touch the glass portion of the
●
light bulb with bare hands. When it is
unavoidable to hold the glass portion,
use and hold with a clean dry cloth to
avoid getting moisture and oils on the
bulb.
Also, if the bulb is scratched or
dropped, it may blow out or crack.
Fully install light bulbs and any parts
●
used to secure them. Failure to do so
may result in heat damage, fire, or
water entering the headlight unit. This
may damage the headlights or cause
condensation to build up on the lens.
507
6