Lexus RX 450h Owner's Manual page 147

off. If the vehicle is refueled without
turning the power switch off, the display
may not be updated.
*4
: This distance is computed based on
your average fuel consumption. As a
result, the actual distance that can be
driven may differ from that displayed.
Energy monitor
■
P.153
AWD Control
■
Displays the driving force applied to
each wheel using segments.
The greater the number of segments
displayed, the greater the driving force
applied.
G-force (if equipped)
■
Displays lateral G-forces on the vehi-
cle. Also displays, around the periph-
ery of the G-force display, the left and
right steering amount, accelerator
pedal input, and brake fluid pressure.
Acceleration G-force on the vehi-
A
cle
Current G-force value (analyzed
B
value of front/rear and left/right
G-forces)
Record of the maximum G-forces
C
Accelerator pedal input
D
� � � � � � � � � � � � � � � � �
2-1. Instrument cluster
Brake fluid pressure
E
Steering amount
F
This display is intended for use as a guide-
line. Depending on factors such as the road
surface condition, temperature and vehicle
speed, the display may not show the actual
condition of the vehicle.
 Resetting the record of maximum
G-forces
Press and hold of the meter control
switch to reset the record.
 Peak hold function
If lateral G-forces of 0.5 G or greater are
generated, the G-force value display will
turn amber and be held for 2 seconds.
Tire pressure (if equipped)
■
P.480
Blank (No items)
■
Displays no drive information contents.
G-force display (if equipped)
■
The G-force values may not be zero even
●
when the vehicle is parked, such as when
it is parked on an incline.
Depending on the vehicle usage condi-
●
tions, the brake fluid pressure display may
not reach its maximum reading even
though the brake pedal is fully depressed.
If a 12-volt battery terminal is discon-
●
nected and reconnected, the steering
amount display may be disabled tempo-
rarily. After driving the vehicle for a while,
the display will be enabled.
Tire pressure (vehicles with a tire infla-
■
tion pressure display function)
• It may take a few minutes to display the
tire inflation pressure after the power
switch is turned to ON mode. It may also
take a few minutes to display the tire infla-
tion pressure after inflation pressure has
145
2