Lexus RX 450h Owner's Manual page 443

 It is recommended that a new bat-
tery be placed in the remote control
transmitter for more accurate pro-
gramming.
 Garage door opener motors manu-
factured after 1995 may be
equipped with rolling code protec-
tion. If this is the case, you may need
a stepladder or other sturdy, safe
device to reach the "Learn" or
"Smart" button on the garage door
opener motor.
Programming HomeLink
■
1 Press and release the HomeLink
button you want to program and
check that the HomeLink
tor light flashes (orange).
Perform 3
indicator light will stop flashing and pro-
gramming will not be able to be com-
pleted.
Point the remote control transmit-
2
ter for the device at the rear view
mirror, 25 to 75 mm (1 to 3 in.)
from the HomeLink
Keep the HomeLink
view while programming.
� � � � � � � � � � � � � � � � �
®
®
indica-
within 60 seconds of 1 , or the
®
buttons.
®
indicator light in
5-6. Using the other interior features
Garage door type A

3 Press and hold the handheld trans-
mitter button until the HomeLink
indicator light changes from slowly
flashing orange to rapidly flashing
green (rolling code) or continu-
ously lit green (fixed code), then
release the button.
®
Garage door type B (Programming

an entry gate/Programming the
®
HomeLink )
3 Press and release the remote con-
trol transmitter button at 2 second
intervals, repeatedly, until the
®
HomeLink
changes from slowly flashing
(orange) to rapidly flashing (green)
(rolling code) or continuously lit
(green) (fixed code).
4 Test the HomeLink
pressing the newly programmed
button and observing the indicator
light:
 Device with fixed code: If the indica-
tor light is solid/continuous, pro-
gramming has been completed and
your garage door or other device
should operate when the
441
®
indicator light
®
operation by
5