Lexus RX 450h Owner's Manual page 444

442 5-6. Using the other interior features
HomeLink
released.
 Device with rolling code: If the indi-
cator light flashes rapidly, your
garage door opener motor (or
other device) is equipped with a roll-
ing code. Complete the program-
ming process by firmly pressing and
holding the programmed
HomeLink
and then release the button.
 If the garage door or other device
does not operate, proceed to "Pro-
gramming a rolling code system".
5 Repeat the steps above to program
another device for any of the
remaining HomeLink
Programming a rolling code sys-
■
tem
1 Locate the "Learn" or "Smart" but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the owner's
manual supplied with the garage door
opener motor for details.
� � � � � � � � � � � � � � � � �
®
button is pressed and
®
button for 2 seconds
®
buttons.
2 Press and release the "Learn" or
"Smart" button.
Perform within 30 seconds after
3
performing 2.
3 Press and hold the desired
®
HomeLink button (inside the
vehicle) for 2 seconds and release
it. Repeat this sequence
(press/hold/release) up to 3 times
to complete programming.
If the garage door opener motor
operates when the HomeLink
button is pressed, the garage door
opener motor recognizes the
®
HomeLink signal.
Enabling 2-way communication
■
with a garage door (except for
Argentina)
When enabled, 2-way communication
allows you to check the status of the
®