Table of Contents
Advertisement
2
Place the original(s) on the original feed
tray or on the glass.
Using the automatic document feeder:
Place them with facing up and align the side
guides to the originals.
Stapling will be done in the position cor-
responding to the upper left corner of the
originals. However, in the 2 in 1 mode, stapling
will be done in the position corresponding
to the lower right corner (see page 72).
● The number of the originals you can set up
at a time is shown below.
Letter
Ledger, Legal, Letter-R :25
Placing the originals on the glass:
Place the original face down on the glass. If
you start with the last page of your originals,
the copies will be arranged in the same page
order as the originals.
The copies can be stapled in the position
corresponding to the upper right corner of
the original.
In this case, however, copies are not stapled
automatically (see page 127 for manual
stapling).
3
Key in the number of copies (sets).
Up to 20 sets can be keyed in (all sizes).
4
Select the desired copy size, image density
level, reproduction ratio, copy quantity,
etc. as required.
:50
2 in 1 stapling position
Stapling position
Stapling position
125
Advertisement
Table of Contents
