Table of Contents
Advertisement
3. TURNING ON THE POWER SWITCH / AUTO JOB START (Cont.)
Auto Job Start
If you set the desired copying modes and press the START key during warm-up, the copier
automatically starts copying when it becomes READY.
1
Place the original(s) on the original feed
tray or on the glass.
When Using the Automatic Document Feeder
● After aligning the edges of the originals, set
them face up on the original feed tray and
align the slides to the edges of the originals.
● See page 24 for the number of the originals
you can set up at a time.
Note: Remove any paper clips or staples from
originals before placing them on the
original feed tray.
When Placing the Original on the Glass
● Lifting the original cover or the reversing
automatic document feeder, place the original
on the glass face down and with its bottom
toward you and with its top left aligned against
the original scale on the left side.
● Close the original cover or the reversing
automatic document feeder slowly after the
original size has been detected.
2
Set the desired copy modes.
● The automatic paper selection (APS) mode
and copying of one original are selected as
the default modes.
22
Slides
Advertisement
Table of Contents
